How to Jump Start a Car

Jumping a car is easier than you think, and you can do it safely with the right steps. All you need is jumper cables and a working car to help you.

If you're trying it out for the first time or need a quick refresher, this guide will walk you through everything step-by-step.

Jumping a car can seem scary, but if you follow the right process, you'll be back on the road in no time.

Let's make sure you know exactly what to do without damaging your car or yourself.

Step 1: Make sure you have the right tools.

Table of Contents

Before you begin, you will need:

Jumper cables (make sure they are in good condition).
A working car with a charged battery.
There is enough space to park both cars close to each other safely.

Step 2: Park the cars safely.

Keep a working car close to a car with a dead battery. Cars should be close enough to reach but not touch the jumper cables. Stop both cars and apply the parking brake to ensure they don't move.

Step 3: Open the bonnet and locate the batteries.

Open the bonnets of both cars and find the batteries. Each battery has two terminals: a positive terminal (marked with “+”) and a negative terminal (marked with “-“). Clean any dirt or corrosion on the terminals to ensure a good connection.

Step 4: Attach the jumper cables.

Carefully follow this order to connect the cables:

Connect the red cable to the positive terminal of the dead battery.
Connect the other end of the red cable to the positive terminal of the working battery.
Connect the black cable to the negative terminal of the working battery.
Connect the other end of the black cable to an unpainted metal surface on the car with the dead battery (like a bolt on the engine block). Do not connect it to the negative terminal of a dead battery to avoid sparks.

Step 5: Start the working car.

Turn on the car with a charged battery and let it run for a few minutes. This will help transfer power to the dead battery.

Step 6: Start the car with a dead battery.

Try starting the car with a dead battery. If it doesn't start immediately, wait a few more minutes and try again. Once started, let both cars run for at least five minutes.

Step 7: Remove the cables in reverse order.

Carefully disconnect the cables in this order:

Remove the black cable from the unpainted metal surface.
Remove the black cable from the working battery.
Remove the red cable from the working battery.
Remove the red cable from the dead battery.

Step 8: Start the engine.

Keep the jump car running for at least 20-30 minutes or drive it around to recharge the battery.

Jumping a car is not as difficult as it seems. By following these steps carefully, you can drive your car safely and avoid potential accidents. Note that if your car battery continues to die, it may need to be replaced, so don't hesitate to have it checked by a mechanic. Safe travels!

The post How to jump start the car appeared first on FakazaNews.

The post How to Jump Start a Car appeared first on Already Viral.